The JCTEST HBRVD-187.5 combines Brinell, Rockwell and Vickers hardness testing in one device. It may be considered for a shared testing workflow, but the available product information does not establish whether it is suitable for frequent relocation between workstations.
Portability requires confirmation. Although the product title uses the term “portable,” it does not establish that the tester is handheld or intended to be moved frequently. Confirm handling and installation requirements before planning a shared-device setup.
Start by comparing the practical constraints at each workstation. A fixed testing station may be easier to manage when samples can be transported safely and the required testing conditions can be maintained in one place. Moving the tester may be worth investigating when samples are difficult to bring to that station, but only after its transport and setup requirements have been confirmed.
The electric HBRVD-187.5 integrates mechanical, electrical and optical technologies and offers multiple test forces and a display for operation and reading. Its three hardness methods provide options for different testing requirements, including work involving quenched, tempered or annealed materials.
Method selection still depends on the material, expected hardness, specimen geometry, surface preparation and applicable standard. Brinell, Rockwell and Vickers results should not be treated as directly interchangeable; any conversion requires an appropriate, applicable conversion reference and should be assessed for the material involved.
Available information does not specify the model’s dimensions, weight, exact test forces or transport provisions. Confirm these details and the standards applicable to the relevant configuration in the formal model documentation.
Use the model manual, handling instructions and written manufacturer guidance to establish whether relocation is permitted and how it should be performed. Do not assume that a method suitable for another hardness tester applies to this model.
A condition check is not calibration. Visual inspection or a routine check does not replace calibration or formal verification. Follow the applicable standard, equipment instructions and your organization’s calibration schedule; seek qualified technical support if the tester is damaged or results are inconsistent.
Share your materials, workpiece dimensions, testing standard and workstation layout with JCTEST to review the intended workflow and request the relevant model documentation. Contact JCTEST via WhatsApp to discuss the requirements.