How to Combine Grinding Papers, Polishing Cloths and Suspensions for Metallographic Preparation
30 10,2026
Laizhou Jincheng Industrial Equipment Co.,Ltd
JCTEST explains how to select and combine abrasive papers, polishing cloths and suspensions when preparing specimens with the MP-2DE double-disc manual machine.
Metallographic surface preparation is a sequence: grinding papers remove cutting damage and progressively refine the surface, while polishing cloths and suspensions help remove the remaining fine scratches. The right combination depends on the specimen material, its condition and the surface quality required for observation.
Match each consumable to its preparation stage
| Stage |
Consumable selection |
What to check |
| Initial grinding |
Choose an abrasive paper coarse enough to remove the existing cutting damage without introducing unnecessarily deep scratches. |
The original damage is removed and the surface has a consistent scratch pattern. |
| Fine grinding |
Move through progressively finer papers suited to the material and the preceding scratch depth. |
Scratches from the previous paper are removed before changing stages. |
| Polishing |
Pair a polishing cloth with a suspension appropriate for the material and the required finish. Follow the consumable supplier’s compatibility and usage instructions. |
Fine grinding scratches are removed without unacceptable deformation, relief or edge damage. |
Build a suitable paper-to-polish sequence
- Assess the specimen. Consider material, hardness, cutting condition, specimen size and whether edges or different phases must be preserved. Mounting can make small or awkward specimens easier to handle and may help protect edges.
- Select the starting paper. Start with the least aggressive paper that can remove the existing surface damage in a practical time. A deeply damaged cut surface may need a coarser starting step than a well-prepared one.
- Refine the scratch pattern. Change to finer papers only after the previous scratches have disappeared. Changing the specimen orientation between grinding steps can make older scratches easier to identify.
- Choose a cloth and suspension together. Their suitability depends on the material and preparation objective; a combination that works for one specimen may cause deformation, relief or edge rounding on another. Use the suppliers’ guidance as a starting point and check the result on the specimen.
- Clean and inspect between stages. Remove abrasive residue from the specimen, holder and work area before moving to a finer consumable. Inspect the surface as needed rather than relying on a fixed preparation time.
Using the MP-2DE for manual preparation
The JCTEST MP-2DE is a double-disc manual metallographic grinding and polishing machine that combines pre-grinding, grinding and polishing. Its dual-control variable-speed operation provides a stated rotation range of 50–600 rpm, and the machine has a high-strength ABS shell.
Select speed and consumables according to the specimen, preparation stage and applicable instructions. Because preparation is manual, consistent handling and regular surface inspection are important. Confirm consumable compatibility and operating details against the machine documentation and the consumable supplier’s instructions.
Troubleshoot the prepared surface
- Deep scratches remain: Check whether the previous grinding step was completed and whether coarse abrasive has contaminated a finer stage. Return to an appropriate earlier step if needed.
- Deformation or smearing appears: Review the abrasive sequence, cloth and suspension pairing, and manual handling. Inspect after adjustments to determine whether the surface improves.
- Edges are rounded or phases show relief: Review specimen support, mounting and polishing conditions. Avoid continuing a stage longer than needed to achieve the intended finish.
- Results vary between specimens: Record the specimen condition, consumables, sequence, speed and preparation observations so that differences can be investigated and the procedure refined.
Choosing consumables for your specimens
For a practical starting point, discuss the specimen material, cutting condition, size, mounting needs and intended examination with the equipment or consumable supplier. For information about the MP-2DE, contact JCTEST with your preparation requirements. Confirm machine specifications and any applicable test requirements using the relevant formal documentation.